PocketWizard FlexTT5 Transceiver Radio Slave for Nikon i-TTL Flash System

Description

Condition:
This
is in great condition showing little to almost no signs of use.
Details:
The
PocketWizard FlexTT5 Transceiver
Radio Slav
e
is part of an ultra-versatile radio slave system, and is dedicated specifically to the Nikon i-TTL flash control system. It simply slides directly into the camera's hot shoe, and there are no special settings to make or modes to call up. Use the camera, on-camera flash, or flash commander controls for flash compensation, zone and ratio control. It supports single or multiple dedicated flash units.
The FlexTT5 is the ideal addition to any Nikon i-TTL flash system. Since this system works on digital radio technology, it can support i-TTL operation around corners, out-of-sight, or in bright sunlight.
The FlexTT5 is a "Transceiver", meaning it can be used either as a transmitter placed into the camera's hot shoe, in combination with another FlexTT5 unit on the flash end, or as a receiver, with a MiniTT1 transmitter-only unit placed on the camera's hot shoe.
Compatability:
Cameras:
D4, D3x, D3s, D3, D2x, D800, D800e, D700, D600, D300, D300s, D200 D90, D80, D40x, D40, D7000, D5100, D5000, D3200, D3100, D3000
Nikon Speedlights as Remotes:
SB-400, SB-600, SB-700, SB-800, SB-900, SB-910
Nikon On-Camera Master Flashes:
SB-700 (GN ratio mode not supported),SB-800, SB-900, SB-910, SU-800)
2 Channel Settings + Learn Mode
Each setting can be programmed to support up to 20 ControlTL channels for TTL photography, or 32 standard channels for manual flash photography. The FlexTT5 Transceiver also has a three-zone selector switch, which integrates with Nikon zones and ratios. The Learn Mode allows the unit to detect the channel used by any other unit in the area.
HyperSync & High-Speed Sync Technology
Supports flash sync speeds of up to 1/500th sec. High-Speed Sync auto syncs flash system with the camera's shutter speed setting, up to 1/8000th.
Built-In Hot Shoe
Features a hot shoe on the top, so that you can still mount a flash unit directly onto the camera. This allows you to combine your remote flash with the on-camera flash, or use the on-camera flash for additional i-TTL control only.
Camera/Flash Ports
The FlexTT5 Transceiver has two plug-in ports for use with remote Nikon i-TTL cameras, or other non-TTL flash units. Camera remote triggering also requires use of a camera-specific "motor cord".
Remote Camera Triggering/Relay Mode
Can be used to trigger a camera remotely. Requires use of a camera-specific "motor cord". Auto Relay Mode allows you to trigger a remote camera in sync with a remote flash.
Low-Profile Design
The FlexTT5 lies flat to stay out of the way and uses a flip-up antenna for additional range when needed.
Configurable and Upgradeable
The FlexTT5 features a mini-USB port, which makes it upgradeable and "future-proof" for continuous improvements and compatibility upgrades. The included PocketWizard Utility software allows you to select custom settings through the USB connection, and to set it to use specific channels used by other Pocket Wizard units.
PocketWizard FlexTT5 Specs
Wireless
Channels52.0
Wireless Range800 to 1200' / 240 to 365 m
Radio Frequency340 to 354 MHz
General
Control ModesTTL
Connectivity
Ports1 x 3.5 mm (Camera Shutter)
1 x 3.5 mm (Flash)
Mounting
Bottom Mount1/4"-20 Thread
Top MountHot Shoe
Electrical
Battery Type2 x AA
Physical
DimensionsTransmitter: 3.6 x 2.8 x 1.4" / 9.2 x 7.1 x 3.6 cm
Weight5.4 oz / 153.1 g